Telemetry Plot

Configuration

Kp CV Ki CV Kp CC Ki CC Kp CP Ki CP Soft-start Step

Output Calibration

Enter the uncalibrated RAW value reported by the device and the value an external meter measured. The host compiles a residual table (exact at your points, linear between them, smoothly decaying to zero outside) and streams it to a dedicated flash region. Corrections are clamped to ±50 V / ±50 mA in firmware. Writing and enabling calibration touch flash, so the output must be off.

Collect points with Apply calibration OFF. Use RAW VSEC / RAW ISEC as the input columns, then enter the external meter readings in the measured columns.

Device table--

CRC--

Applied--

Apply calibration to the control loop (saved to config flash)

Voltage points

RAW VSEC, meter V, and optionally meter current (mA) for load-dependent correction.

RAW VSEC (V) Meter V Meter I (mA, opt)

Current points

RAW ISEC (mA) and meter I (mA), collected while calibration is disabled.

RAW ISEC (mA) Meter I (mA)

Advanced: decay radius

Voltage R (V) Current R (mA)

A lone point fades to zero roughly R away from it. Larger R spreads each correction further.